Safe numbers are 40 psi for oxygen and 10 psi for acetylene regardless of tip size. Simply adjust them until you get a neutral flame.
When brazing with oxy acetylene what pressures should the ... - Quora
When brazing with oxy acetylene what pressures should the regulators be set to?
How to set the oxy acetylene regulators - Tech Team Products
18/02/2019 — First were going to adjust the regulator before we get started. If you turn it clockwise that increases pressure. Thats a little backwards ...
rule of thumb (multi-hole cutting tips oxy / acetylene) - Badger Welding
Single-hole tips are usually stamped with a one or a two-digit number. Set both your fuel-gas regulator and oxygen regulator pressure to this stamped number- ...
How to Set Up an Oxy Acetylene Torch - wikiHow
Close both torch valves. For the oxygen turn the pressure-adjusting screw on the regulator until the gauge reads about 25 psi. For the acetylene turn the ...
The pressure setting for oxy-acetylene welding- Express
19/04/2022 — The pressure of the two gas cylinders is adjusted by turning the regulator screw on each cylinder clockwise. You must first open the gas bottle ...
Regulator settings for Cutting - American Welding Society
For 3/16 to 1/4 thick steel using a #0 cutting tip your settings should be about 30 psi for oxygen and about 4 psi for acetylene. At 12 psi ...
Oxygen And Acetylene Regulators - mewelding.com
11/06/2022 — The regulators which are used at the head of an oxygen or acetylene manifold have only gage – that is the low pressure gage. The gage on the ...